I created a new query using the query designer. It has one parameter. WHen I run in the query designer it works just fine. I then saved the .qry
When I create a new crystal report 8.5 using this query the parameter does not show up anywhere!&$*(&$
Any idea's as to what I am doing wrong.
I am going against a sybase database.
I know I could make the query a stored procedure and it would work fine. But... I am trying to do a work around to a situation where there is a mortitorium on new stored procedures but NOT new reports. I am trying to backdoor the system. Once the mortitorium is over I would make it a stored procedure.
Any help would be appreciated.
When I create a new crystal report 8.5 using this query the parameter does not show up anywhere!&$*(&$
Any idea's as to what I am doing wrong.
I am going against a sybase database.
I know I could make the query a stored procedure and it would work fine. But... I am trying to do a work around to a situation where there is a mortitorium on new stored procedures but NOT new reports. I am trying to backdoor the system. Once the mortitorium is over I would make it a stored procedure.
Any help would be appreciated.