Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Panasonic Programming/Backup software

Status
Not open for further replies.

joebit

MIS
Feb 21, 2008
17
AU
Hi all,
Can anybody help me?? I need to change my KX-TD1232 system over to a replacement system of the same. I've bought the replacement and tested it and sees to work fine but i need to transfer all the settings from the old system to the new before i change it over. Does anybody have the Panasonic backup restore software they can lend me. Or any other software that will perform the same procedure. I'm located in Australia.
regards
Joe
 
there is a small removable cover in the centre of the main unit when you open the door, can you tell me what the numbers are on each of the eproms?
Also , on the Panasonic label on the outside of the system, what are the letters after 1232?

if both systems are the same software version , it shouldn't be too hard to change
 
eproms wont matter. the 1232 programming tool will save a database as the latest version of the tool. make sure the programming tool is an older version and will talk to a Dash-6 and you would be good to go. Good luck finding an old win98 PC that will run the old DOS tool and has a serial port. Program tool attached
 
 http://files.engineering.com/getfile.aspx?folder=2a5345f4-aaf8-4a23-8a1b-ae3eb3750c8b&file=E1232A-DOS.exe
tobeage thanks for the file. Could anybody please confirm I only need the programming tool (software) and an old laptop running win98 with a serial port and the correct serial cable (Null modem) to backup the unit?? Not sure what the eproms numbers are without checking but its the Australian model so the letters after the 1232 are AL.
 
it will run on xp and 32 bit windows 7 in compatible mode.

if it is the dos tool it does have to be the correct version, it will connect but because of differences in programming fields it wont open all pages

the windows tool will work from version 4 to 6
 
obtsystems !!! you just blablabla and no help to anybody just search for find a customer for sale . this site isjust technical problem and no for sale .
 
@ INLSP04.
I really don't know whats you up with you or what you are trying to say. learn to speak properly then come back and talk to me.


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top