KenshinHimura
Programmer
Is there a way for the RGB values to range from 0 - 255 in Qbasic? And how do you change the palette in SVGA modes?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Palette
- Thread starter KenshinHimura
- Start date
- Status
qbasicking
Programmer
No, 63 is the maximum, and qbasic doesn't have an SVGA mode (VGA, and EGA only). If you are using a library then you would have to use the functions present in the library itself.
- Thread starter
- #3
KenshinHimura
Programmer
Well, you can get SVGA in Qbasic using asm, but it doesn't matter anymore. I found out how to change an 8-bit palette into Qbasic's 6-bit one. Thx neway 
- Thread starter
- #5
KenshinHimura
Programmer
I'm not too big on usin libraries since I don't learn anything from them. Do you know where I could find some good SVGA tutorials (doesn't matter the language)? thx
- Status