Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Paging trunk working fine inside the pbx, but not from the oustide

Status
Not open for further replies.

stfontaine

Technical User
Mar 11, 2008
12
CA
Hi !
I'm using a trunk as a paging, connected to an amplifier. It's working fine from the inside(from all the phone connected thru this pbx).

I do have external system, connected thru T1 (qsig) and when I'm dialing the ACOD, I have a fastbusy.

I tryed changing the TGAR of the paging trunk route without any success.

I can dial RAN route from the outside (thru the same T1), but not paging route. Is is possible to fix this ?

Thanks !

Stephane Fontaine
 
using DID ACODs? Wow.

Make a MAXP 1 NCFW to page ACOD ACDN

dial the ACDN - should work.

Mato' Was'aka
 
DAMN !

It's working !

I did that (the acd translation) earlier this morning and it was not working ! Now, it is. Not only the acd translation, but the ACOD itself.

For your information, I won't put a DID on this paging trunk ! The ACOD will have 10 digits (impossible to remember it) and It will be programmed on speed dial button.

Thanks for your quick reply !

Stephane
 
I found what I did to make it work.

NACC = PGNU (it's PNGR by default).

NACC = Network access control

(PGNR) Paging route is PAGENET restricted
PGNC Paging route is PAGENET controlled
PGNU Paging route is PAGENET uncontrolled

Steph.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top