Paging trunk working fine inside the pbx, but not from the oustide

[stfontaine]

Hi !
I'm using a trunk as a paging, connected to an amplifier. It's working fine from the inside(from all the phone connected thru this pbx).

I do have external system, connected thru T1 (qsig) and when I'm dialing the ACOD, I have a fastbusy.

I tryed changing the TGAR of the paging trunk route without any success.

I can dial RAN route from the outside (thru the same T1), but not paging route. Is is possible to fix this ?

Thanks !

Stephane Fontaine

 

[bigindian65]

using DID ACODs? Wow.

Make a MAXP 1 NCFW to page ACOD ACDN

dial the ACDN - should work.

Mato' Was'aka

 

[stfontaine]

DAMN !

It's working !

I did that (the acd translation) earlier this morning and it was not working ! Now, it is. Not only the acd translation, but the ACOD itself.

For your information, I won't put a DID on this paging trunk ! The ACOD will have 10 digits (impossible to remember it) and It will be programmed on speed dial button.

Thanks for your quick reply !

Stephane

 

[stfontaine]

I found what I did to make it work.

NACC = PGNU (it's PNGR by default).

NACC = Network access control

(PGNR) Paging route is PAGENET restricted
PGNC Paging route is PAGENET controlled
PGNU Paging route is PAGENET uncontrolled

Steph.