Paging to VoIP trunk network

[bashboosh]

Hi
Is it possible to page to the DNs at another VoIP site? How do we configure this if it is possible?

Thanks

 

[oldestgeek]

Algo makes a device that can convert your analog paging audio to IP and back again at the other site.

 

[bashboosh]

Without third party appliance/application, is it not possible in BCM itself?

 

[cook1082]

I know on remote packages there was a remote page.But I think it uses dial tone for page.

 

[bashboosh]

I read somewhere, the remote paging is not available for IP trunks, is it right?

 

[cook1082]

Your are correct just looked at the doc and IP trunks are not supported for remote page.

 

[bashboosh]

Thanks for the replies.
OK, instead of paging, voice call to individual set is possible in IP trunk?

Regards

 

[BombOne]

do you have 2 bcms one at site A and one at site B with voip trunks between, or one bcm at site A with ip sets off it at site b? If the second set up is what you have, then you can page just like any other phone, just put the sets at site B in a different page zone.

 

[bashboosh]

Bombone,
I have 2 BCMs one at site A, and one at site B with voip trunks between, all are digital phones (i dont have ip phones).

Still possible?

 

[NARSBARS]

If, instead of paging, you can voice call to individual sets, you can put one of your IP sets from site A at site B. Set the second set to allow voice page and steal the speaker leads for input to the paging system.

Now, does anyone know if you can voice page to an IP set over IP trunks?




NARSBARS

 

[BombOne]

That is a good Idea Nars has. If you did that you could even page to that phone, just put it in its own zone. I did this at a location before that was using a Norstar with MCK extenders, I wanted to page at the remote site and did this.

 

[stsguy]

i put 1 analog line on the system and programmed it as disa line. this would allow me to page over thier external paging system remoteley.