Paging to/from a remote location 2

[NSupporttech]

I have a MICS7.0 with a 6 port fiber card connected to a MCK that interfaces with MM Fiber on both sides which is connected to an 0X8 module at a remote location, well now they want paging at this remote location which was not talked about prior to. Can one of these analog ports be put in its own paging zone then connect it to the Tip/Ring of a paging horn to receive pages? Then how to page from the remote location back to the main bldg via analog ports. Any thought's appreciated.Thanks

 

[exsmogger]

You'll need a paging amp that allows a tip & ring input. Then you'd just dial the extension number of the analog station port being used for paging. Check out Valcom amps.

Brian Cox

http://www.jandjcommunications.com

 

[SuckMyIrish]

You can also hook a Analog port into a CO port and set the CO port to autoanswer. Call the analog ext. from any phone and once it answers you can press *6X to page. This is the only way to page when you are dealing with mulitple BCMs in multiple locations. I am sure it works on MICs/CICs as well.