Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

paging question 1

Status
Not open for further replies.

bparr

Technical User
Feb 11, 2009
25
US
I just found out that there is a code that a user can enter to page over our loudspeaker paging. The code is 60*. Where would this be programed? It is not in fearture access codes. I am lost.
 
ch pag loud" should get you there.

When is the last time you helped someone, just because you were able to?

For the best response to a question, read faq690-6594


 
is the TAC field the number that you use to access it? WHat does TAC mean. the other place I have seen it is in list trunk and use in the list trace tac.
 
Code Calling — TAC
This field assigns a Trunk Access Code (TAC) to a paging zone. Users dial this code to make a
page to a specific zone. One TAC must be assigned to each zone you want to use. Two zones
cannot have the same TAC. If you enter a TAC in the ALL field, users can activate speakers in
all the zones by dialing that code.

When is the last time you helped someone, just because you were able to?

For the best response to a question, read faq690-6594


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top