Paging loudspeaker

[osonegro]

Hello, I am trying to add a new paging loudspeaker configuration in the AVAYA equipment, but I am receiving the next error when I try to load the configuration:

"Cannot enable dial access, same first digit used for extensions", do you know what is happen?

Best regards.

 

[captainnick666]

you have to use a dial code that is not used by something else, check your dial plan for an entry with DAC or MISC

 

[osonegro]

LOUDSPEAKER PAGING

CDR? y
Voice Paging Timeout (sec): 30
Code Calling Playing Cycles: 2

PAGING PORT ASSIGNMENTS
Voice Paging Code Calling
Zone Port TAC COR TN TAC COR TN Location:
1: 1A1201 860 38 1 861 38 1 tst
2: 1 1 PAGING
3: 1 1 PAGING

Here is the dial plan

0 4 ext 84 3 dac
0 5 ext 85 3 dac
1 3 fac 86 3 dac
2 3 dac 9 1 fac
2 4 ext * 2 fac
2 5 ext # 2 fac
3 4 ext
3 5 ext
4 4 ext
5 4 ext
5 5 ext
6 4 ext
6 5 ext
7 4 ext
7 5 ext

I used the range 86 with 3 digits as a dac, please let me know your comments

 

[98Converter]

Depending on your software version, maybe you have a second digit table...?

Thanks,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[osonegro]

I will try to change the dial plan to aviod the problem, because I dont have a second digit table, do you know the command to verify the second digit table ....?

Please let me know if there is a way to trace this or where can get a pdf with all the errors in the pbx and see the different root cause of this pbx answer.

 

[98Converter]

It would've been change second-digit x...

But this is on older software loads.

Thanks,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[osonegro]

No this command is not in my system, I have a G3Rv11, so I really dont know yet what could be causing this pbx's answer, so the next step is to change the dial plan, but this will take more time because I am using extensions in all the ranges assigned in the dial plan.

Best regards.

 

[4merAvaya]

Your existing paging system is using 860. You also have an entry of 861 for Code Call. What code are you trying to assign?

Kevin