cardinalGLZ
MIS
Hello,
I currently have a successful PRI Trunk connecting to a Gateway device... I currently run a hybrid system, asterisk PBX and an Option 11c... I wanted to see how I could access paging across this PRI... I currently can cross communicate to 2616 / 500 sets directly with DIDs but trying to page has been a bear... I didn't know if there was a tweak to allow this TN to accessed from outside? It would make sense to block this because you wouldn't want someone from another facility paging... Currently from a 500 or 2616 set, I can dial 820 for loop then 00-07 for zones...Not sure if something is blocked or if I need pauses from VOIP side... The gateway handles conversion to PRI when passed DID from VOIP, maybe there is a way to change page loop to treat like a DID? Any tricks?
I currently have a successful PRI Trunk connecting to a Gateway device... I currently run a hybrid system, asterisk PBX and an Option 11c... I wanted to see how I could access paging across this PRI... I currently can cross communicate to 2616 / 500 sets directly with DIDs but trying to page has been a bear... I didn't know if there was a tweak to allow this TN to accessed from outside? It would make sense to block this because you wouldn't want someone from another facility paging... Currently from a 500 or 2616 set, I can dial 820 for loop then 00-07 for zones...Not sure if something is blocked or if I need pauses from VOIP side... The gateway handles conversion to PRI when passed DID from VOIP, maybe there is a way to change page loop to treat like a DID? Any tricks?