Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

P690 partition 1

Status
Not open for further replies.

we2aresame

Technical User
Feb 10, 2003
128
CA
There is a question on a ibm redbook:
A new p690 with 8 CPUs, 8GB mem, and 2 I/O drawers. Whtat the maximum number of partitions allowable with this size of machine?
The giving answer is 6
I thought that if using 256MB as the memory of each partition, then the maximum possible should be 8.
Any suggestion? Thanks.
 
No limitation from the question. Even using Large Real Mode Memory(>=1G), I thought the answer should be 7, thanks.
 
You must have at least 1 processor and 256 Mb of memory per partition (in AIX 5.1 / 5.2)..
You have at least 4 block of 4 disks by I/O drawer.... Each block can be dissociated.... One block=One partition.

Then in your configuration, you can have maximum 8 partitions....
 
[tt]

I suspect that the Redbook you refer to is old - the smallest amount of memory you could allocate to an LPAR used to be 1Gb. This would make the 6 LPAR maximum correct - the memory would be allocated like this:

0000Mb-0256Mb For the hypervisor
0256Mb-0512Mb For the Page Table space. As the LPAR memory is 1Gb, each LPAR requires 1/64th of this for page table space. 1/64th of 1Gb is 16Mb. Only one page table space of 256Mb is required as all LPARs can 'fit' into this one.
0512Mb-1024Mb cannot be allocated as partitions with 1Gb memory have to start on a 1Gb boundary.
1024Mb-2048Mb for LPAR 1
2048Mb-3072Mb for LPAR 2
3072Mb-4096Mb for LPAR 3
4096Mb-5120Mb for LPAR 4
5120Mm-6144Mb for LPAR 5
6144Mb-7168Mb for LPAR 6
7168Mb-7936Mb not big enough for any further 1Gb LPAR
7936Mb-8192Mb for TCE (256MB if 4 or less I/O drawers)

Nowadays we can allocate 256Mb to a partition, so we can use all 8 processors and I/O drawer boot disks to get 8 LPARS:

0000Mb-0256Mb For the hypervisor
0256Mb-0512Mb For the Page table space. As the LPAR memory is 256Mb, each LPAR requires 1/64th of this for page table space. 1/64th of 256Mb is 4Mb. Only one page table space of 256Mb is required as all LPARs can 'fit' into this one.
0512Mb-0768Mb for LPAR 1
0768Mb-1024Mb for LPAR 2
1024Mb-1280Mb for LPAR 3
1280Mb-1536Mb for LPAR 4
1536Mb-1792Mb for LPAR 5
1792Mb-2048Mb for LPAR 6
2048Mb-2304Mb for LPAR 7
2304Mb-2560Mb for LPAR 8
2560Mb-7936Mb Free
7936Mb-8192Mb for TCE (256MB if 4 or less I/O drawers)

I hope that clears it up for you.


[/tt]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top