Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

p333t sw_image upgrade bank A & B

Status
Not open for further replies.
dozer

dozer

IS-IT--Management
Jan 25, 2001
2
US
After upgrading to latest image and do a show image ver both banks A & B appear to be upgraded but when the switch is reset only one bank will show the upgraded image ver. Is this normal. Is there a command to fix this. Is the set boot bank command relate to this.
 
Sort by date Sort by votes
Hi,

The problem you meet is normal.
The latest image are to large to enter only in on bank and it is copied on time into the two banks.

Regards,

Luc.
 
Upvote 0 Downvote
Thanks for the post, I was begining to think I was the only person this happened to.

Dozer
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Tre0307
  • Locked
  • Question
Need help with Upgrade recommendations
Replies
1
Views
387
Westi
Westi
gcam10
  • Question
Looking for a Non DS DR5 Card in Canada
Replies
5
Views
681
Masson
Masson
dibthree
  • Locked
  • Question
upgrade ERS 4800 from standard image to secure image
Replies
1
Views
160
PPrash
PPrash
AlfonsoSF
  • Locked
  • Question
how to configure a port with two or more vlans
Replies
0
Views
241
AlfonsoSF
AlfonsoSF
matelot2
  • Locked
  • Question
wiring a BCM50 1
Replies
3
Views
183
curlycord
curlycord

Part and Inventory Search

Sponsor

Back
Top