P2P T1 on networked Legend

[FordMan77]

I have 2 Legends that are networked together via a straight p2p T1. I have all the prog. in place (non-lcl udp, trunks, etc...). I have made calls from the remote site to the main site with no problem. When I try to make a call from the main to remote site, all I get is silence, and occasionally it just drops the trunk altogether. When I dial my remote site, I see the amber light come up on the 100D card but the call never completes. If I stay on the line long enough I hear screeching occasionally. Anyone know what could be a possible cause?

 

[glg01]

When I mentioned moving the 012 card to N2 it was only for testing purposes whether it was a 007MLM or not it would have worked for the test since it has 2 TTR's and with the configuration you posted it was the only viable one to use. Sounds like you have that 016 TR module for your solution so calling between N1 and N2 should be resolved. I have never used this "Tie Line" setup for centralized vms. By the book (your last comment indicates you use them) it should be Legend/Magix PRI network programming but I would be interested in knowing if all the features worked...mwi lighting, coverage working properly, night service from N2 covering to N1, etc. Going over this in my mind...I don't know for sure a couple of things may work but I wouldn't think it would be clean. Have you done Centralized VMS with this setup before? In my second entry above I mention the some of the "Why's" you would use the PRI setup and you might re-read dagwoodsystems comments for he is right on and posted a thread to go to. As you continue with this project I feel we may hear from you again with a few other issues. lg