(OVL428) locked out 1

[Harlock1]

Hi,

I had a problem under LD 117 doing a ucm registration.
The MGC card tried a few times and failed, I eventually figured out what went wrong.

But now the system "locked" out my admin2 user.

I can rlogin to the system, then I enter cslogin or csconsole and get my CS prompt.

When I do a logi admin2 and password I get (OVL428)

How do I reset this password from UCM?
Or anywhere else for that matter.

 

[bigindian65]

wait 30 to 60 minutes.

Mato' Was'aka

 

[Harlock1]

Ok, and if that does not work?

 

[bigindian65]

lcko is usually 30 min default or 60, so I don't know beyond that, other than ini

Mato' Was'aka

 

[yyrkroon]

(OVL428) is not lockout - ovl400 is. ovl428 is wrong login/pwd combination.

you'll have to login into ucm as nortel and access your security domain and reset your pwd.

 

[bigindian65]

thx for cleanup

Mato' Was'aka

 

[Harlock1]

I would not be asking the question if I did not try to do it, I can't find the reset feature for CS1000_Admin2 in the UCM, only for admin and nortel user, not for admin2 ...

My question is ... where in UCM do you reset the CS users passwords for admin2

 

[guycable2]

Maybe thats the problem. No admin2 built in the UCM.

 

[Firebird Scrambler]

You can only use the "old" ADMIN1 / ADMIN2 logins etc if the IP link is disconnected, otherwise it's the UCM logins. This still applies if you are on a serial port!.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.