Does anyone have experience setting up an interface between a paging system and a CCM? I assume that a VG200 with FXO ports would do the job nicely. Does anyone know of a simple/cheaper way?
Cut the speaker wire in one of your phones, put it in an intercom group by itself, and wire it to a overhead paging zone controller. You should even be able to pass on DTMF to your zone controller that way, to select individual zones.
to provide an analog port and plug a zone paging module into it. The ATA units are pretty cheap - under $200. If you don't already have a paging module that has an analog port input the Bogen PCM2000 (
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.