I can not find a description for the trunk group parameter "outgoing seizure response(sec)" in the documentation I have. When I created this CAS trunk it defaulted to a value of 5. This is a 2-way CAAS trunk and I am trouble shooting a potential glare condition. I have this trunk group set to "back-off" but not sure if it really is or is backinf off to slow. I was hoping to get an idea of what this timer is before I start changing it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Andrzejek on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
outgoing seizure response timer?
- Thread starter tipnring
- Start date
Enter the maximum interval that the switch should wait after
sending a seizure signal to receive seizure acknowledgment
from the far-end.
If the acknowledgment is not received in this time, a seizure failure response is uplinked.
hope that this short description will help you
Greets, Bob
sending a seizure signal to receive seizure acknowledgment
from the far-end.
If the acknowledgment is not received in this time, a seizure failure response is uplinked.
hope that this short description will help you
Greets, Bob
- Status
Similar threads
- Locked
- Question