Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Outgoing line on a BCM50
- Thread starter plshlp123
- Start date
You have to configure routing/destination codes when using PRI. Target lines are "inbound only". Configure a destination code of 9, point it to a new route that points to pool bloca (assuming that's where your PRI lines are), give the phones access to pool bloca, and you should be set.
- Status
Similar threads
- Question
- Question