Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Outgoing CLI When diverting to System Speed Dial

Status
Not open for further replies.

qldlgtech

Technical User
May 11, 2011
17
AU
I have a question on an Ipecs 50 B

When System is Nightswitched the calls are being Forwarded to System Speed Dial (Mobile Phone )

Call comes in & out to Customers mobile phone showing ISDN GDN Number

Question : Is there a way in the phone system to show the callers number on customers mobile instead of GDN ?

Cheers Rob
 
Hi Rob

if you are on BT ISDN i don't think you can

if you are on SIP trunks certan providers will alow you can pass the CLI through the system and back out again
 
Hi Rob
On ISDN30 (PRI) ISDN supplementary services could be enabled at the exchange (for a cost) The iPECS ISDN line side will need to be set for this feature too. ISDN-SS CD/CR feature would need to be Call Re-routing.

On ISDN2 (BRI) ISDN supplementary services could be enabled at the exchange (for a cost).. but with BRI ccts - there are two options available at the exchange.. If the exchange sets the ISDN2 up as an MSN - this is Call Deflection, if they set up the ISDN 2 as DDI - then the setting is Call Re-routing. The ISDN lines on the system, ISDN-SS CD/CR feature would need to be set as per exchange..

As in the previous reply - SIP providers usually allow the CLI to pass through.

Regards Steve

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top