NSupporttech
Programmer
I have a CP-150 connected to MICS w/6.1XC and I am programming a simple x-fer to an external # using CCR.
I am using lines in pool B so the option 7 in the CCR is setup as a x-fer to EXT using pool 2.
I see the system grab the line then it continiosly tells me the routing is incorrect.The tree is enabled and I have verified all the programming. I have set this up before but have not experienced this particular problem. Any insight greatly appreciated.
I am using lines in pool B so the option 7 in the CCR is setup as a x-fer to EXT using pool 2.
I see the system grab the line then it continiosly tells me the routing is incorrect.The tree is enabled and I have verified all the programming. I have set this up before but have not experienced this particular problem. Any insight greatly appreciated.
