Outbound traffic trought a QSIG

[meridianino]

I have one master-slave nortel pbx and a QSIG with another philips pabx. I want to program on the slave nortel a group of 20 sets that take outbound on philps making the zero that all the others sets . Which tables and programs do i need to configure on both the nortel pbx for translate and trasmit that zero on philips pabx ?

 

[johnpoole]

a couple of steps necessary for that one.. in ld 86 you'll need a rlb/rli pointing to the route.. in the same load you can build and use a dgt/dmi table to delete any dialed digit you don't want to send end to end and insert any digits you might want to add.. in load 87..new cdp 0 dsc to add a distant steering code.. these must be unused digits in your nortel.. i dial 2xxx... that is a dsc (distant steering code) i cab use just the 2 or 2x 2xx, 2xxx.. x=any unique digit.. that sends it to a rlb (route list block) that picks my route, if i have a dmi, i can insert 0,(the actual digits i need to insert) delete 2 (number of ditits- 2 would be delete the 1st 2).. i would send 02x out route?.. the frl entry in the rlb sets the access level (who can use this route)... if you have the actual digits you want to dial in switch a, and what you want to reach in switch b, and the route and can fill in the blanks for you

john poole
bellsouth business
columbia,sc