Outbound routing over legend network

[perlmonky]

I have a 100d card with a cross over to asterisk pbx system, I can dial extensions on either system. The problem that I have is that from the asterisk system when I send over a number to dial that requires outgoing trunks, I get the operator and the call does not go out.

I have spent time researching ARS Tables and Barrier Codes and haven't been able to find what I am looking for. Any suggestions for allowing the Remote Access to the Asterisk PRI?

A DS1 SLOT ATTRIBUTES

A Slot Type Format Supp Signal LineComp
A 5 PRI ESF B8ZS DMI-MOS 2


A Slot 5 Switch: Legend-Ntwk
A BchnlGrp #: Slot: TestTelNum: NtwkServ: Incoming Routing:
A 80 5 ElecTandNtwk Route Directly to UDP

A Channel ID: 23 22 21 20 19 18 17 16 15 14
A 13 12 11 10 9 8 7 6 5 4
A 3 2 1

A Line PhoneNumber NumberToSend
A 809
A 810
A 811
A 812
A 813
A 814
A 815
A 816
A PRI INFORMATION


A 817
A 818
A 819
A 820
A 821
A 822
A 823
A 824
A 825
A 826
A 827
A 828
A 829
A 830
A 831

 

[merlinman]

Set REMOTE ACCESS for all "TIE & NON-TIE" to be UNRESTRICTED.

This should fix your problem.

 

[perlmonky]

Will this affect access on my local and long distance PRI's? Or will this be specific to my tandem PRI.

 

[merlinman]

Can those be accessed by anything to do Remote Access?

I doubt it.

THe deal is, when your are trying to call from one Switch to another, the Legend/Magix knows it is trying to connect on a TRUNK TO TRUNK basis.