Outbound digits

[sglis]

Hi
I am currently upgrading my local service from a T-1 to PRI. We are in an area with 10 digit dialing. The PRI is working correctly for inbound calls but is only sending out 7 digits to Bell. Where do I set the # of digits allowed on the new route? Thanks

Ken

 

[sglis]

Sorry - Its an option 51C.

I have changed the rli to the new route.

 

[vztech]

Turn on you DCH messaging in LD 96 to see what you are sending.You may need to look in LD 15 at your CLID table.

 

[sglis]

My CLID info is as follows. our numbers are in the 704-593-xxxx range. Does the following look right?

ENTRY 0
HNTN 704
ESA_HLCL 593
ESA_INHN NO
ESA_APDN YES
HLCL 593
DIDN YES
HLOC
LSC

thanks

 

[sglis]

I fixed the problem. 704 was entered as an nxx in ld 90. I removed this entry and added it back as an spn pointing to the same rli. Afterwards all 10 digits were passed. I dont' know if this is the ideal setup but it works.

thanks for the ideas regarding ld 96

 

[PERRYPJ]

YOU CAN ADD IT AS AN NPA, BUT INSTEAD OF 1XXX YOU JUST ENTER XXX

OLD ROLMEN WORKING ON NORTELS