Outbound Dialing Assistance 1

[Realign]

Avaya G311

Good Morning All,
I have reviewed various threads and was just wondering if there was an easier way. I have a list of 65 extensions I would like to add to a digit conversion table. These extensions have their own DID’s off network. So, for example, ext 490410 would route directly to xxx-xxx-xxxx. The issue I am having is my current dialplan is 4 digits with numeral 4 in use. So I cant add 49-length of 6 or anything like that. I can get it dial using ARS however I have to dial 9 to get out of the system. Anyway of dialing these 6 digits directly and having the system convert them to the associated DID?

07:59:49 dial 4904
07:59:49 denial station
07:59:50 idle station
07:59:51 tone-receiver
07:59:51 active station
08:00:01 dial 9490410#
08:00:01 term trunk-group 30 cid 0x212
08:00:01 dial 9490410#
08:00:01 route-pattern 2 preference 1 cid 0x212
08:00:01 seize trunk-group 30 member 27 cid 0x212
08:00:04 dial 9490410#
08:00:04 outpulse done 1xxxxxxxxxx

 

[Ronster]

If you have your 4xxx extensions limited to not using 49xx then you could setup your dialplan like this:

Dialed  Total  Call
String  Length Type
40      4      ext
41      4      ext
42      4      ext
.
.
49      6      ars

_______________________________________________________________
A cucumber should be well sliced, and dressed with pepper and vinegar, and then thrown out, as good for nothing. SAMUEL JOHNSON (1709-1784)

 

[Realign]

Thank you, thank you, thank you. I knew it was something trivial. I will be kicking myself for months on not catching it. You have been a tremendous help. Just breaking out the 4xxx extensions worked perfectly.