We have a Mer 61C. The CLI set in the CLID table works fine for outbound calls dialed over routes and trunks defined as DID, but does not work with routes and trunks defined as TIE. Can anyone help?
Johnpoole is right.
Change the RCAP prompt in DCH definition to ND2 or ND3 on the both sides !
These entries are possibles if you connect 2 Nortel PBXs together with SL1 protocol.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.