What are the proper settings for the PBX to control the ANI going out over a PRI? I know about public unknown numbering, but what about on the TG side and RP if anything? The carrier is saying I should be able to control this, but I don't think so. I think they have a block on that and it's just passing the btn.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Outbound ANI
- Thread starter btrain08
- Start date
- Thread starter
- #3
This is all I see on the trace. I see what number was dialed.. not what was sent out..
12:15:43 dial 912125835101 route
REFIX|FNPA|ARS
12:15:43 route-pattern 312 preference 1 cid 0x382c
12:15:43 seize trunk-group 206 member 10 cid 0x382c
12:15:43 Setup digits 12125835101
12:15:43 Calling Number & Name NO-CPNumber NO-CPName
12:15:43 G711MU ssff ps:20
rgn:1 [10.192.112.13]:5968
rgn:4 [10.192.56.13]:2056
12:15:43 Proceed trunk-group 206 member 10 cid 0x382c
12:15:46 Alert trunk-group 206 member 10 cid 0x382c
12:15:51 idle station 5101 cid 0x382c
12:15:43 dial 912125835101 route
REFIX|FNPA|ARS12:15:43 route-pattern 312 preference 1 cid 0x382c
12:15:43 seize trunk-group 206 member 10 cid 0x382c
12:15:43 Setup digits 12125835101
12:15:43 Calling Number & Name NO-CPNumber NO-CPName
12:15:43 G711MU ss
ff ps:20rgn:1 [10.192.112.13]:5968
rgn:4 [10.192.56.13]:2056
12:15:43 Proceed trunk-group 206 member 10 cid 0x382c
12:15:46 Alert trunk-group 206 member 10 cid 0x382c
12:15:51 idle station 5101 cid 0x382c
Well, you're not sending it. Do you have "send calling number" on page 3 set?
change trunk-group 8 Page 3 of 21
TRUNK FEATURES
ACA Assignment? n Measured: both Wideband Support? n
Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: n Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: public
-CL
change trunk-group 8 Page 3 of 21
TRUNK FEATURES
ACA Assignment? n Measured: both Wideband Support? n
Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: n Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: public
-CL
- Thread starter
- #5
- Thread starter
- #7
- Thread starter
- #8
Group Number: 206 Group Type: isdn CDR Reports: y
Group Name: AT&T COR: 1 TN: 1 TAC: 1136
Direction: two-way OutgoingDisplay?n Carrier Medium: PRI/BRI
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: public-ntwrk Auth Code? n TestCall ITC: rest
Far End Test Line No:
TestCall BCC: 4
============================================================
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol:a Digit Handling: enbloc/enbloc
Trunk Hunt: cyclical
Digital Loss Group: 13
Incoming Calling Number - Delete: Insert: Format:
Bit Rate: 1200 Synchronization: async Duplex: fll
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
Administer Timers? n CONNECT Reliable When Call Leaves ISDN? n
============================================================
ACA Assignment? n Measured: none Wideband Support? n
Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: public
Outgoing Channel ID Encoding: preferred UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Network Call Redirection: none Hold/Unhold Notifications? n
Send UUI IE?y Modify Tandem Calling Number? n
Send UCID? n
Send Codeset 6/7 LAI IE? y Ds1 Echo Cancellation? n
Apply Local Ringback? n US NI Delayed Calling Name Update? n
Show ANSWERED BY on Display? y
Network (Japan) Needs Connect Before Disconnect? n
Group Name: AT&T COR: 1 TN: 1 TAC: 1136
Direction: two-way OutgoingDisplay?n Carrier Medium: PRI/BRI
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: public-ntwrk Auth Code? n TestCall ITC: rest
Far End Test Line No:
TestCall BCC: 4
============================================================
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol:a Digit Handling: enbloc/enbloc
Trunk Hunt: cyclical
Digital Loss Group: 13
Incoming Calling Number - Delete: Insert: Format:
Bit Rate: 1200 Synchronization: async Duplex: fll
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0
Administer Timers? n CONNECT Reliable When Call Leaves ISDN? n
============================================================
ACA Assignment? n Measured: none Wideband Support? n
Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: public
Outgoing Channel ID Encoding: preferred UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Network Call Redirection: none Hold/Unhold Notifications? n
Send UUI IE?y Modify Tandem Calling Number? n
Send UCID? n
Send Codeset 6/7 LAI IE? y Ds1 Echo Cancellation? n
Apply Local Ringback? n US NI Delayed Calling Name Update? n
Show ANSWERED BY on Display? y
Network (Japan) Needs Connect Before Disconnect? n
- Thread starter
- #10
- Thread starter
- #12
well the reason it shows that is because the site is a remote site on the west coast and to test I set up a local extension with a remote coverage path that goes to 212-583-5101, which is my NY extension so when I call the local # the call will go out over the pstn and I can see the # when it calls me.
- Status
Similar threads
