OSV V10 simplex to duplex migration

[Wolf-ACG]

Hi community
I have an issue when trying to make migration from DB simplex to DB Duplex whit next message

Toolkit does not support interface change!

Can any one help me?

 

[sbcsu]

My method - Probably wrong but it will work - would be to download a REGEN and other information from the Simplex and make a new Duplex off site.
How are you doing the migration ?

 

[Wolf-ACG]

My method - Probably wrong but it will work - would be to download a REGEN and other information from the Simplex and make a new Duplex off site.
How are you doing the migration ?

Many thank for your help but I'm meaning an openscape voice migration and regen is for openscape 4000

 

[sbcsu]

OK I understand - you are changing system from 4000 to OSV

 

[Wolf-ACG]

OK I understand - you are changing system from 4000 to OSV

No is migration from OSV V10 simplex to OSV V10 Duplex

 

[sbcsu]

OK - Maybe there is a recommended way

But - I would start a new Duplex install
and then go to site with the new processor and hard disks
Shutdown the existing simplex - install the new processor, cables and hard drives and start up systems.

You will need to generate an XML from the existing simplex
also generate a REGEN file and make note of the system settings for the assistant, stmix etc.

Also you will have to get licences but not immediately

 

[Moriendi]

sbcsu there is no 4K here. This is an OSV simplex to duplex migration.

I am no OSV expert but the OSV installation manual deals with simplex to duplex migration with specific steps and handling. Wolf-ACG are you following those steps? Because the manual is comprehensive and I would expect it to work. It sounds like you are missing something, but I don't know enough about it.

 

[sbcsu]

OK sorry about that - I was looking at it and seeing V10 - my mistake - good luck with upgrade !

 

[wanyin]

chapter 9.1.2 maybe useful