Hi,
I am installing an OS4000 V11 system with two softgates. I am planning to keep both softgates in BPool for redundancy for IP Phones. I have configured one card for HFA terminals and BPool is also configured.
But I am facing a problem that the board switchover is happening only once. The scenario is as follows.
vSTMI 1-17-4 and vSTMI 1-18-4 is configured and normal and stand by gateways.
BPOOL 1 is configued with same vSTMIs.
At first sat 1-17-4 is in normal and 1-18-4 in standby ready. At this time when i disconnect the LAN of LTU 17 (softgate) the vSTMI 1-18-4 changes to normal and 1-7-4 changes to standby defect.
When i connect back the LAN of LTU 17, 1-17-4 comes to standby ready and 1-18-4 continues to be Normal.
At this point when i disconnect the LAN of LTU 18 (softgate), 1-18-4 changes to Normal Unach. The 1-17-4 continues to be stand by ready. This status doesnot change and HFA phones remains down.
At this point if I delete the Bpool and create again switchover will happen but again only once.
the procedure i used is as follows
ADD-BCSU:ipgW WITH FCTBLK having HG3530
ADD-CGWB:NORMAL
ADD-BCSU:IPGW with FCTBLK having standby
ADD_CGWB:STANDBYRDY;
ADD-BPOOL:AP, pool no, ltua=17, slot 4 , ltub=18, slot 4
Any help is highly appreciated.
I am installing an OS4000 V11 system with two softgates. I am planning to keep both softgates in BPool for redundancy for IP Phones. I have configured one card for HFA terminals and BPool is also configured.
But I am facing a problem that the board switchover is happening only once. The scenario is as follows.
vSTMI 1-17-4 and vSTMI 1-18-4 is configured and normal and stand by gateways.
BPOOL 1 is configued with same vSTMIs.
At first sat 1-17-4 is in normal and 1-18-4 in standby ready. At this time when i disconnect the LAN of LTU 17 (softgate) the vSTMI 1-18-4 changes to normal and 1-7-4 changes to standby defect.
When i connect back the LAN of LTU 17, 1-17-4 comes to standby ready and 1-18-4 continues to be Normal.
At this point when i disconnect the LAN of LTU 18 (softgate), 1-18-4 changes to Normal Unach. The 1-17-4 continues to be stand by ready. This status doesnot change and HFA phones remains down.
At this point if I delete the Bpool and create again switchover will happen but again only once.
the procedure i used is as follows
ADD-BCSU:ipgW WITH FCTBLK having HG3530
ADD-CGWB:NORMAL
ADD-BCSU:IPGW with FCTBLK having standby
ADD_CGWB:STANDBYRDY;
ADD-BPOOL:AP, pool no, ltua=17, slot 4 , ltub=18, slot 4
Any help is highly appreciated.