Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Optipath 3550 1

Status
Not open for further replies.

meanmofo

Programmer
May 24, 2010
63
AU
Hi there
I don't normally work on these systems but have been handed a job to make a few changes.
I need to either connect via serial and make programming changes or can use the main handset if needed.
Does anyone have a link to the manager software?
Is there a default password?
Anyone got a copy of the prog manual?
I have done a search but am not getting very far.
TIA
Mofo
 
Hi,
As you know the HiPath 3550 can be programmed using the main phone *9531994/31994
And/Or the Serial interface.

Program to install and documentation/help files are available at

Click on Guest Login
Username:hipath4000
Password:hipath4000

The program is located in folder 150 300 OSB
and documentation is located in Docs / 150 3000 OSB

When the program is installed the default username/password is 31994 31994
It may be different on your system but that is the default mostly used
 
Thanks a million sbcsu
I will give it a crack and see what happens.
 
hi sbcsu
Managed to get into the PBX via the main phone. Thanks for your help.
Manager software worked up until it queried the username and password then crashed. I use an XP laptop.
Have you had issues with the software at all?
 
Hi,
It should ask you the username/password at the start
just put in
Username:31994
Password:31994
On the phone you have to put in the extra *95 at the start to get into the programming mode
XP Should be OK as far as I know
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top