Option 11c Terminal question

[newbietech01]

I have an Opt 11C system with a VT420 terminal attached. I went into the settings to change the backspace key on the keyboard to be backspace and when I exited all i had was a blinking cursor in the upper left hand corner. I can't seem to get it to start its session again. I tried powering it off and back on again with no luck and when I press the F4 key (configured as session) the system just beeps at me. Anyone have any suggestions?

Joe Baxter
IT Specialist
TransCare, Inc

 

[Johnthephoneguy]

Did you accidentally hit the hold key i think it is called on the top row?

JohnThePhoneGuy

"If I can't fix it, it's not broke!

 

[newbietech01]

No, Hold key is definitely not on

Joe Baxter
IT Specialist
TransCare, Inc

 

[tnphoneman]

Reset to factory defaults and start over on the config. You can not back sapce on the terminal for the PBX.


Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[GHTROUT]

In order to activate the ability to use backspace, the PBX needs "Line Mode On"

OVL000
>LON

To turn it off...
OVL000
>LOF

That feature is otherwise known as "LON and LOF" Sometimes it screws up older terminals...and it's easy to turn it on by mistake:

>LON
- ooops
>LOGI

GHTROUT.com | FAQs | Recent Replies