999said999
Technical User
Hi,
I have two option 11c cabinets. the 1st has cppm & MGC plus 1 PRI with clock controller & D-channel. the 2nd cabinet only has 1 MGC and 1 PRI without clock controller. I am getting DTA301 error every 3 minutes that cause the loop to go down when the counter reaches 255.
Questions:
what is the cause of the error?
can I make the rcnt command to reset the slip deletion counter before it reaches 255?
do I need another clock controller for the 2nd PRI in the other cabinet? and How do I configure it (release 6)?
the cc led in the 1st pri is red (maybe cc is disabled) what is the command to enable it?
Thanks
I have two option 11c cabinets. the 1st has cppm & MGC plus 1 PRI with clock controller & D-channel. the 2nd cabinet only has 1 MGC and 1 PRI without clock controller. I am getting DTA301 error every 3 minutes that cause the loop to go down when the counter reaches 255.
Questions:
what is the cause of the error?
can I make the rcnt command to reset the slip deletion counter before it reaches 255?
do I need another clock controller for the 2nd PRI in the other cabinet? and How do I configure it (release 6)?
the cc led in the 1st pri is red (maybe cc is disabled) what is the command to enable it?
Thanks