Optimal Solution? 2

[VoipNewbie]

Hey Everyone,

Im new to the phone switch world. We currently have a main pbx connected via fusion to our other switches around the university.

We recently built a new dorm and had 50 analog lines put in direct from telco. Now we are considering bringing them onto our phone network. This building is across the street from the main campus so we would need to get a circuit from sbc im assuming.

Would it be best to go with a single pim imx or even a dru setup?? Please let me know why which solution may be better. I can use all the knowledge you guys are willing to tell me!!

Thanks in advance.

 

[VoipNewbie]

anyone?

 

[mextera]

No prices here, see a local dealer for help.

 

[VoipNewbie]

no estimates?

and does anyone have any ide on the cards i asked about last?

 

[mextera]

CP24-B MP card used for DRS
PAD card either 8IPLA or 32IPLA
If you use the 8IPLA then you would not need another card for Codec selection G7.29

For the TDM side you need...
CP24-B
7 - 8 port Anaolg cards 8LCAA
1 - 8RST Analog register card
2 PIM's Cabinets one for TDM and one for VOIP

 

[VoipNewbie]

There arent any 16 port cards in this unit?

What are those first three cards you listed? used for ip? or are they to hook me up to my other imx?

 

[mextera]

No 16 port cards they are 8 port slots only. (Smaller PBX)

They are VOIP cards

The cards to connect to the IMX are a 24CCTA card. thats on the 2000 side. Not sure whats needed on the IMX.

 

[VoipNewbie]

Thanks Mextera... once again you have managed to help me out greatly. I appreciate it.