OPT11c moving clock from lp1 to loop 2

[trclubb]

We have a customer that is dropping the t-1 (nt8d09) in loop 1. this card has the clock on it. i looked it ld73 and saw where pref was lp1. after the change all they will have is lp2. i was hopping to just change the pref from 1 to 2 in load 73 and then move the NT8D09 w/clk over to new loop. looks to me looks this should have no problems.

should i look at anouther way.

 

[KCFLHRC]

You will also have to change at the CLKN prompt

 

[trclubb]

so in LD 73 both CLKN & pref would chg to the new loop

 

[KCFLHRC]

Correct