Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

OPT11c moving clock from lp1 to loop 2

Status
Not open for further replies.

trclubb

Vendor
Mar 20, 2009
83
US
We have a customer that is dropping the t-1 (nt8d09) in loop 1. this card has the clock on it. i looked it ld73 and saw where pref was lp1. after the change all they will have is lp2. i was hopping to just change the pref from 1 to 2 in load 73 and then move the NT8D09 w/clk over to new loop. looks to me looks this should have no problems.

should i look at anouther way.
 
You will also have to change at the CLKN prompt
 
so in LD 73 both CLKN & pref would chg to the new loop
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top