opt 11c not loading all ports at start-up 1

[definity101]

We have an opt11c test switch set up with only a few phones. When the system is initialized in the morning, the only active ports are the ones with phones attached. I have to do an LD 11 and easy chg every time to activate the ports. I'm thinking there's some command that can be changed in the config. that will activate all ports in the start-up. Any simple solutions?

 

[johnpoole]

not a single command to break the switch but.. you do not have to do a echg..

ld 32
enlc 4

will enable all disabled phones on that card.. even if the card itself is enabled... are you running procomm, if so a script would enable each card

john poole
bellsouth business
columbia,sc

 

[definity101]

Thanks for the info. I was hoping for something I could change in the cust. database. I guess we'll have to get a computer set up just for that switch. If I'm not here the other tech's can't test on the disabled ports.

 

[MagnaRGP]

Take loads 32 and 36 out of the midnight routines.

also ld 32

ENLS X will enable all programmed ports in cabinet X

where X = 0 to 4

 

[definity101]

Thanks MagnaRGP, the ld 32..enls worked great!