Opt. 11 PRI install

[ringbacktone]

I have an order to swap out a T1 for a PRI. There is no dial up cabilities, so I am not certain what software releas they are running. Pretty sure they will need an upgrade cause I am reasonably sure they have never upgraded at all. I would like input from forum prior to going to site next week Listed below are my questions.
What revision level do I need for the TMDI? What software rls for Opt 11 for PRI ? What is part number for daughter board that mounts to TMDI for clocking?
Thanks in advance,

RBT

 

[phones1]

what protocal are you (a) outing (guessing DASS) (b) installing (If UK guessing ETSI). since your provider can no doubt provide many protocals they are all generally pkg dependant on the Opt11. Your best bet is to prt the pkg's & look them up against the NTP's.

Good Luck

Remember if it doesn't work hit it harder

Scott UK

 

[Tacosoup]

http://pbxbook.com/meridian/t1_install.html

Here is a very good document for it including part numbers. (Thank you Mike)

I dont remember what software release allowed a pri, but you will need to verify they can add the circuit with their currnet licenses.

 

[ringbacktone]

Have not been to site as yet. I am reasonably sure that removal of the T1 ckts will allow for adding 24 TN's/ licenses, with regard to protocal we would be set as B8ZS/ESF and NI2. Thanks for the document.

RBT