OPEN PORT using CONDUIT Command

[pvr13]

Please explain me how to open a PORT on PIX firwall Ver 6.3 using CONDUIT command

Is it absolutle necessary to have static IP each PORT that I OPEN,

Requirement is to OPEN say TCP PORT 2000 inbound

Do I have to use Conduit and static then I need static IP?

Or Is it possible just OPEN Conduit only?

Regards
PVR

 

[boymarty24]

May i ask why you use conduit and not statics/access-list.

Conduits are much slower then access lists and conduits are old way to do it.

 

[pvr13]

Thanks for your response

That is because this was maintened by my seniors with old concept (Using CONDUIT/STATIC instead ACCESS LIST), Now I have make some immidiate changes.

I am looking forward to change ACCESS-List soon,