One number solution

[jas0nh]

Hi we have an IP 500 which we will be intergrating with Lync 2010, i can route DDIs to Lync users but what i would like to know if anybody has managed to setup a DDI that rings Mobile phone, Lync and desktop phone al at the same time.

Any advice would be helpfull thanks

 

[jas0nh]

Anybody ????

 

[hairlessupportmonkey]

You might want to set up some virtual users on the switch to forward the calls off to the lync softphone, then have all the devices twinned.

ACSS - SME
General Geek

 

[intrigrant]

You cannot have that, twinning can only be done with two targets unless MS Lync can do that ( I don't think so but surprise me )

A simple mind delivers great solutions

 

[tlpeter]

When you integrate Lync with the IP500 then i suggest to go for the client integration.
Lync will be a add on to your despphone.
Then you can also use mobile twinning.
Lync as a softphone is not supported on the IPO.


BAZINGA!

I'm not insane, my mother had me tested!

 

[jas0nh]

Nearly there,

I managed to set simultaneoussly ring in lync to my internal extension and my user has mobility twinning enabled when i call my DDI my lync software rings and my desktop phone rings but my mobile does not ring at all even though i have mobility twinning enabled.