OLI on MICS not working with PRI trunks

[GrumSFC]

Hi i have a Modular system with PRI trunks, the OLI was being sent but after i played with the configuration to resolve some seperate issues the OLI does not seem to send anymore. Does anyone know how to resolve this?

Graham

 

[senk1s]

dont we love the undo button in Office?

What SW version do you have?

Under telco features there is a setting which says send OLI or not

 

[jerryreeve]

You'll want to make sure that the local telco will accept OLI from you.

I think that on most of the software releases for PRI that you cannot have a system name assigned.

----------------------------
JerryReeve
Communications Systems Int'l
com-sys.com

 

[GrumSFC]

Yeah the undo button would be perfect!

Its a GP9 SW level, the weird thing is i didn't turn the OLI off but what i did do was reset all the DDI's because i wanted to change the received lenghs to four rather than three. Maybe this reset it....i'll have to go have a look and get back to you.

Thanks for your responses...

Graham

 

[senk1s]

GP9 sw? are u in europe ...
i was referring to the setting on a US system

 

[jerryreeve]

I think if you changed the target received number length it will reset the expected numbers in each target, it should not change the OLI though.

----------------------------
JerryReeve
Communications Systems Int'l
com-sys.com

 

[GrumSFC]

i haven't had chance to go back to site and check and play with it yet but shall do hopefully during this coming week.... i just want to be a little prepared.
Yeah Senks, i'm in England so i think the SW revisons differ slightly but i'm pretty sure the programming options are the same?
What confuses me is that its presenting a witheld? I would have expected it to just send the bearer number of the channel being used?

Graham