We have an app in the field that uses the Nz() function. Some users are now getting an error using that function. The order of the references somehow gets reset, with OLE Automation now at the bottom, which then causes Nz() to throw an error.
There is discussion that this may be because they have an app that is installing the Access 97 RUNTIME, which may or may not have that function.
I know that Nz is available in Access 97, but is it in the RUNTIME?
If you have other suggestions on how the order of refferences might get reset within the app, that would be helpful as well. So far we have had 3 instances.
Thank you very much in advance for your help.
Ahliana
Argue for your limitations and, sure enough, they're yours! - Richard Bach
There is discussion that this may be because they have an app that is installing the Access 97 RUNTIME, which may or may not have that function.
I know that Nz is available in Access 97, but is it in the RUNTIME?
If you have other suggestions on how the order of refferences might get reset within the app, that would be helpful as well. So far we have had 3 instances.
Thank you very much in advance for your help.
Ahliana
Argue for your limitations and, sure enough, they're yours! - Richard Bach