NUTRI PARAMETERS

[Chukwuemeka]

My client has a direct connect from a public switch and the digits being sent from the switch are 00&&99, while the internal directory is 4001&&4099.Meanwhile, he wants some digits 00&&09&80&&99 to ring at the Operator which is 4000.The other digits will ring at the marching extensions
Eg. digit 10 goes to extension 4010 and so on. Note that the Operator number 4000 is also the DISA number. A caller dials 2709700 and expects to reach Operator on 4000 and dials 2709710 and expect to reach extension 4010.
How do I set NUTRI parameters.

 

[lalrl]

If a nutri for public route (Euro-ISDN) is already set, then check, that cont=1 is used. Then in my market for conversion of 10 to 4010:

nutri:entry=10,rou=x,cnvtyp=0,numtyp=12,pre=40;

If no nutri exist so far, you must allow numberconversion in route with rocac:rou=x,sel=xxxxxxxxx1;

 

[Chukwuemeka]

Thanks.

It works fine with 4010, but dose not work on 4000.In fact it works well in all extensions but not for operator.

Note that 4000 is an operator.
How do I handle Operator setting.

 

[wfhy]

Hello,

You should do
-nutri:entry=00,rou=x,cnvtyp=0,numtyp=12,pre=40;
-nansi:numtyp=od,numse=4000;

good luck

wfhy

 

[DUFQI]

thats's not the way DID-calls to the operator should be handled.
As I read 00&&09&80&&99 are DID numbers to the operator.
So initiate these numbers as OI and assign them in OPCTS.
nutri:entry=AA,rou=x,cnvtyp=0,numtyp=12,pre=40;has to be done for (AA)1,2,3,4,5,6,7
More help

 

[eriuser]

Why use NUTRI at all, just put a PRE of 40 onto the route using
RONDI:ROU=XX,PRE=40;
Then assign 4000,4009,4080&4099 as NUMTYP=OD in numanal
Then make these numbers goto the switchboard using
OPCTS:CORG=YY,CALT=7,ROU=XX,OACC=4000;
etc.