Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NTDW20 programming

Status
Not open for further replies.

BRUE23

Vendor
Apr 4, 2023
3
US
Have worked/repaired these for some time but have a unit that says on boot "to change configuration enter mgcsetup".
After entering IP info it asks for "ADA MGMT IP address".
I have never seen this before. If I bypass it returns to "to change configuration enter mgcsetup".
Anyone seen this or can be of any assistance?
Thank you
 
I thought ITS like an MGC (Apart from having 2 ports one for each shelf) you just do IP Address/Mask/Gateway and CS Address, then no to the Advanced Parameters
 
maybe it is in a sec domain and after the UCM/SMGR whichever you are using
 
Thanks bignose, the cards were connected to Avaya Aura so we had to default/replace hardware to get them back to "normal".
Thanks for your help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top