nsrjb not showing the output correctly 1

[walnut2980]

I ran nsrjb to get information about the tapes and found that the output is not consistent with the tape numbers in the slots. Looks like nsrjb is not able to fetch a refreshed set of information about the tapes. Please advise if anybody has run into similar situation.

 

[605]

This may happen due to various reasons. Run "nsrhb -HEv" and then rerun an inventory.

 

[walnut2980]

Thank you very much

running 1) nsrjb -HEv
2) nsrjb -Iv
helped me fix the problem.

I had to run the same sequence of commands a couple of times though but it works great.