Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

not reading entire hd

Status
Not open for further replies.

Rapster

Technical User
May 12, 2006
9
US
i recently installed a 320 gig wd harddrive as data storage on my comp and it all worked well until i restarted my comp and it gave me this error to format the disk. since i didnt have any info in it i did. But it reads the hd as a 127 gig. This isnt good. I went to disk managment and it says that its a 127 gig. i used partition magic and i gave me the same problem =( anyone can help me plz
 
edit* also btw im runnig windows xp pro
 
I am assuming this is an IDE drive.

It sounds like a 48-bit LBA issue.

See:

Two things are necessary to use the full drive capacity:

1) BIOS support - does your BIOS report the full 320GB capacity? If not, you may find a BIOS flash on the board manuufacturer's site to enable large drive capacities.

2) Windows XP must be at least at the Service Pack 1 (SP1) level
 
Thanks very much forgot to install service pack and when i did all worked well thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top