i recently installed a 320 gig wd harddrive as data storage on my comp and it all worked well until i restarted my comp and it gave me this error to format the disk. since i didnt have any info in it i did. But it reads the hd as a 127 gig. This isnt good. I went to disk managment and it says that its a 127 gig. i used partition magic and i gave me the same problem =( anyone can help me plz
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
not reading entire hd
- Thread starter Rapster
- Start date
- Thread starter
- #2
I am assuming this is an IDE drive.
It sounds like a 48-bit LBA issue.
See:
Two things are necessary to use the full drive capacity:
1) BIOS support - does your BIOS report the full 320GB capacity? If not, you may find a BIOS flash on the board manuufacturer's site to enable large drive capacities.
2) Windows XP must be at least at the Service Pack 1 (SP1) level
It sounds like a 48-bit LBA issue.
See:
Two things are necessary to use the full drive capacity:
1) BIOS support - does your BIOS report the full 320GB capacity? If not, you may find a BIOS flash on the board manuufacturer's site to enable large drive capacities.
2) Windows XP must be at least at the Service Pack 1 (SP1) level
- Thread starter
- #4
- Status