We have a location with a Nortel MICS 4.0 that was recently installed. Customer says Line 3 is not working. Had telco out and tested fine to panel. What can be done to test programming and / or bad hardware? Trying to walk someone over the phone to help since it is quite a distance away. Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Nortel MICS
- Thread starter loaiza
- Start date
RikRodgers
Vendor
Sam173 and lugerlover are right. Any troubleshooting would require a punch tool and butt set.
curlycord
Programmer
First I would ask them did they skip the 3rd and 4th pin then terminate line 3 onto the 5th or did the terminate line 3 onto the 3rd pin which is wrong, you can see the wire pinouts in the FAQs tab.
Also try pin 6.
12||34||56||78 is correct
123||||||||||| is in correct
Also try pin 6.
12||34||56||78 is correct
123||||||||||| is in correct
- Status
Similar threads
- Locked
- Question