Nortel Meridian - Which loops are using which dch's? 3

[olympus41]

I am trying to find out which of my loops (T1's) are using which DCH's. I keep seeing DCH 3 on my PBX "RLS" then "EST", and I can't figure out which loops are using that DCH. Please help. Thank you.

 

[phonejack99]

Easiest way is LD 60 Stat 24th channel of each loop will be your DCH.

Proper setup of DCH's inludes using the DES field fo just this type of info.

 

[RBeaudoin]

Go to LD60 and do a stat. When you find the loop that has the dch go into LD11 and do a PRT TYPE:TNB. Print off the first TN of the LOOP. You will be able to see the Route it is on. Then go into LD21 and do a PRT TYPE:LTM and enter the Route#. This will list all the members on the route including the TN's which will give you your LOOPS.

 

[Jay2003]

LD 22
REQ PRT
TYPE ADAN DCH x
ret

Check the DCHL section, This will give you your loop.

Cheers

Jason