newtelcomm
Vendor
I have 2 Nortel systems I am tring to connect. Both are just blinking where the inservice light is suppose to be steady. I try dialing the other system and it says no lines avaliable. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Nortel DTI card blinks
- Thread starter newtelcomm
- Start date
- Status
- Thread starter
- #22
newtelcomm
Vendor
No, it isnt yet. I have a combo card on the way.
- Thread starter
- #23
newtelcomm
Vendor
Got combo card in and both lights are gren. The programing I have done isnt letting it communicate from one system to the other.
- Thread starter
- #24
newtelcomm
Vendor
I can dial line pool on each system and enter ext. # but it doesnt dial. Where am I messing up at.
- Thread starter
- #25
newtelcomm
Vendor
Got both systems to dial each other now. Just need to figure out how to get the voice mail to work on the second system.
RikRodgers
Vendor
You'll need MCDN codes for both systems if you're using one vm for both cabinets.
- Thread starter
- #27
endlesswinter
IS-IT--Management
look into the voicemail doc's on centralized voicemail
- Status
Similar threads
- Locked
- Question
