Hello all,
I am relatively new to the Nortel world and have picked up a small project to have 4 IP phones installed into a remote office.
We have a CS1000e v5.5 in place at our main site and we have a small office in another location.
We are wanting to install 4 phones into the remote office and have them connect to the our telephony over the existing Cisco LAN via ISDN30 WAN.
I was wondering if anyone could rendor any advice or issues that will occur if we where to just install the 4 phones and place them on the same voice VLAN as in our main site and point the phones towards are main building signal servers?
Many Thanks in advance for any assistance.
I am relatively new to the Nortel world and have picked up a small project to have 4 IP phones installed into a remote office.
We have a CS1000e v5.5 in place at our main site and we have a small office in another location.
We are wanting to install 4 phones into the remote office and have them connect to the our telephony over the existing Cisco LAN via ISDN30 WAN.
I was wondering if anyone could rendor any advice or issues that will occur if we where to just install the 4 phones and place them on the same voice VLAN as in our main site and point the phones towards are main building signal servers?
Many Thanks in advance for any assistance.