Nortel BCM50 and DTMF Tones

[enguser]

Just installed a BCM50 with two (2) analog lines to a Fax Server. The Fax Server needs to hear DTMF tones.

How do I configure the BCM50 to deliver DTMF tones to the two analog lines?

Thank you,

 

[dj4020]

no configuration needed the analog lines need to be connected to an ASM (Anaolog Station Module.) That will provide your DTMF. You should be posting this in the Business Communications Manager BCM Forum

 

[enguser]

Thank you dj4020, I located the Business Communications Manager BCM Forum. New to this forum would you happen to know how I can transfer this posting?

Not sure if I was clear, however I have a PRI that is handing off to a BCM50 configured to output two (2) Analog numbers out of a block of DID's.

These two analog numbers are routed through a Patch Panel to a Fax Server.

Not wanting to purchase another piece of hardware, is there not a way to configure the BCM for just those to lines to send DTMF?