nortel 1140e

[harrisjt]

can the 1140 be used on a BCM with 3.7 software?

 

[Firebird Scrambler]

It might work, but it wouldn't be supported.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[norstarboy125]

I tried it before and it didn't work. Nortel says you need 3.0 or higher to run 1100 series sets.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[ucxguy]

The device type reported by the 1100 series phones is not recognized by the 3.7 software. Due to that, the phone won't work with that software release.

 

[Firebird Scrambler]

Whilst on this topic, we found that a Nortel conference phone 2033?. worked fine on a BCM 200 3.6. We know it's not supported, but then the BCM 200 or 3.6 isn't either!.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[ucxguy]

The type reported by the 2033 conference phone is i2001 phase 16. Very old BCM releases didn't check for a particular phase and enabled IP phones based on the type only. The type reported by the 1140 phone is i2004 phase 37 - it's quite likely that you could use the 1140E phone with the BCM 3.6 software, too.

 

[harrisjt]

I just tried it and it did work. Running BCM 3.7